3/4
File 02 · Flight Controller
A flight controller, minus what you don’t need.
An RP2354 dual-core M33 running Betaflight on a 6-layer board: a 6-axis IMU, microSD blackbox, PIO-driven analog OSD (in development), and a switchable 10 V VTX rail. No barometer, no onboard radio. Bring your own RX over UART and keep the board small and cheap.
OSHWA certified · BE000026Model· pick your build
Coming soonSKU OPENFC-LITE-3030
Teardown
- RP2354B · dual M33 @ 150 MHz×1
- LSM6DSV16X · 6-axis IMU×1
- microSD blackbox (SPI)×1
- Analog OSD×1
- Switchable VTX / 5 V buck×1
- Gyro 1.8 V LDO×1
- 3.3 V logic LDO×1
- USB-C + power mux×1
- JST-SH I/O connectors×1
- I/O
Published so you can study it. Produced so you don't have to.
In the box
- 1×OpenFC Lite board
- 1×8-pin JST SH ESC harness
- 4×M3 rubber soft-mount grommets
- 1×Build cardbatch ID, QC initials, firmware flash command, GitHub rev
Provenance
- DesignedLeuven, Belgium · schematic, PCB, BOM, firmware partnerships
- AssembledShenzhen, China · first runs, while we bring up an EU line
- NextEU assembly · in planning
Every spec, one table
- Firmware
- Betaflight, custom RP2350 target (upstreaming in progress)
- MCU
- RP2354, dual M33 @ 150 MHz, 2 MB flash
- IMU
- ST LSM6DSV16X on SPI; LGA-14 footprint also takes TDK ICM-426xx
- Blackbox
- microSD card (TF-021B)
- OSD
- Analog, PIO-driven (in development); digital OSD via MSP DisplayPort
- Motor outputs
- 4× DShot, bidirectional telemetry
- RX
- External, over UART (CRSF/SBUS)
- Power
- 3S–6S; switchable 10 V + always-on 5 V (3 A-rated bucks)
- USB
- USB-C (config + UF2 flash)
- Layers
- 6
- License
- CERN-OHL-S-2.0
- UARTs
- 4: 2 hardware + 2 PIO
- Size
- 30.5×30.5 mm, 6-layer
Manufacturer
- Company
- Incutec BV
- Address
- Stapelhuisstraat 15, 3000 Leuven, Belgium
- contact@opendrone.be
